![]() ![]() ![]() It would have been easier if I had just attached the ground wire to the bivert prior to installing the bivert. While doing the ground wire I had to be careful to not over-solder and inadvertently connect the ground of the bivert module to that socket pin that ends up directly underneath it, which was blobbed pretty heavily with solder. I did the pin-lift method, soldered the through holes and pins and then did the ground wire last. I'd recommend soldering the ground wire onto the bivert board ground pad BEFORE soldering it to the gameboy board and pins. the ground pad on the corner sort of lays over where pin 1 for the ribbon socket are on the logic board, and that ground pad is right up against the corner of the chip. I installed the bivert mod while also adding the screen backlight, which I highly recommend! All in all this is a near perfect product.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |